C28H OMRON PDF

Find great deals for Omron C28H-C6DR-DE PLC. Shop with confidence on eBay!. OMRON C28H-C6DR-DE-V1 SYSMAC C28H MINI H-TYPE PROGRAMMABLE CONTROLLER: : Industrial & Scientific. Remember that Omron assign pin 9 to the GND wire, on PLC side. You need a ‘CIF02 cable’ adapter but if the C28H plc has a Rs port.

Author: JoJonris Zuran
Country: Pacific Islands
Language: English (Spanish)
Genre: Finance
Published (Last): 24 September 2004
Pages: 388
PDF File Size: 10.78 Mb
ePub File Size: 10.9 Mb
ISBN: 576-1-31768-449-2
Downloads: 46031
Price: Free* [*Free Regsitration Required]
Uploader: Mum

Started by udhaya24 Nov Posted 24 Nov Posted 25 Nov edited.

How to communicate with c28h Programable controller. – Other Omron Software –

Posted 25 Nov Posted 26 Nov Posted 28 C28j You need to be a member in order to leave a comment. Sign up for a new account in our community.

How to communicate with c28h Programable controller. Hi friends, I’m using Sysmac c28h programable controller, the problem with the controller is, it’s not switching to RUN mode, I think we need to change the parameters in startup settings, due to that improper settings the cpu is not changing to RUN mode, even after rebooting the PLC.

  INFLUENZA A Y B PDF

I tried f28h steps mentioned in this link http: Share this post Link to post Share on other sites.

Jumper pin7 to pin9 and the software should connect. But i don’t know how to communicate with this PLC. I’ll tell you what are all the hardware and software configuration which i have made C28h Programable controller System cofiguration: I’m using Windows 8.

In syswin there is no option for auto online, so i’ll create new project with f28h plc cxxh, then in project communications I’m selecting the Baud rate, type of protocol, i don’t know wat is the baud rate of plc, so i’ll test the plc with all baud rate and It’s showing the error “no response from PLC”. What can i do Edited 25 Nov by udhaya.

Omron C28H-C6DR-DE-V1 (C28HC6DRDEV1) – Axdos AB | PLCSWEDEN | Automation Spare Parts

It plugs into the front of the C28H omrno has a 25 pin serial port on the front of it. This was not mentioned, so just in case, make sure that you have the above Host Omton adapter.

  CUBO DI RUBIK SOLUZIONE PDF

We have been talking about the built in serial port which does support host link but used pin 7 rather than pin 9 for signal ground. I still doubt that udhaya has constructed the correct cable based on the supplied drawing.

How to communicate with c28h Programable controller.

I am going to post a simpler schematic for that cable Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community.

Register a new account.

Sign in Already have an account? Sign In Sign Up.